real axis

In the thermodynamic limit, the zeros accumulate nearly the transition point z_0 in the real axis and the density of zeros near z_0 determines the order of the phase transition.

在热力学极限下，配分函数零点在正实轴上集聚的那些点z0给出了相变的位置，同时在z0附近的配分函数零点密度决定了相变的类型。

The deep-basement sinkbox construction technique of 1000-ton real 3-axis experiment fitment

1000t真三轴试验机深基础沉箱法施工技术

By setting two perspective cameras at the first molars of the upper jaw and using the OpenGL selection mode, the real-time collision detection with high efficiency between lower and upper jaws can be realized as the lower jaw rotates around the axis of the articulator.

该方法通过在上颌左右第一磨牙近中舌尖处建立透视视景体，利用OpenGL的选择模式，可以实时地检测下颌模型绕牙合架转动轴线旋转过程中与上颌模型碰撞对位情况，效率很高。

The Cole-Cole plot appears to be a segment of arc in the complex ε plane, and the center of circle is below the real axis.

此时的Cole-Cole图在复ε平面上成为一段圆弧，圆心在实轴以下。

As experiments, the above protocol model was employed in a CAN bus based 3-axis CNC system, and the results prove that the presented protocol has a good performance in real time and motion synchronization control.

最后将上述协议模型用于CAN总线分布式三轴数控系统进行实验，结果证明该系统在通信实时性和运动同步控制方面具有良好的性能。

With the help of the conformal transformation, we transform a simply connected region and its boundary into the upper half plane and real axis.

借助保形变换将单连通区域及其边界化为上半平面与实轴。

The dynamic measurement and analysis of MSG-325 2-AXIS NC Diamond Tool Lathe manufactured by Rank Pneumo Inc. USA are presented in this paper and the modal parameters of the lathe are identified by means of real modal analysis method and complex model analysis method respectively.

本文针对美国Rank Pneumo公司生产的MSG-325型双轴数控金刚石车床进行动态测试与分析，并分别用实模态与复模态两种方法识别了该机床的模态参数。